Filter
Top Products
5
UTILITY PACKAGE (GX Configurator-TI)
5.2 Installing and Uninstalling Utility Package
5.2.1 Precautions for use
5 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PROCEDURES AND
SETTINGS BEFORE
SYSTEM OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
5.2 Installing and Uninstalling Utility Package
For installation and uninstallation of an utility package, refer to the "Method of installing the
MELSOFT Series" provided with the utility package.
5.2.1 Precautions for use
This section describes the precautions for using GX Configurator-TI.
(1) Safety
Since GX Configurator-TI is add-in software for GX Developer, read "Safety
Precautions" and the basic operating procedures in the GX Developer Operating
Manual.
(2) Installation
GX Configurator-TI shall be added in GX Developer Version 4 or later. Therefore, it
must be installed on the personal computer that has already been GX Developer
Version 4 or later installed.
(3) Screen display error when intelligent function module utility is used
Insufficient system resource may cause inappropriate display of the screen when the
intelligent function module utility is used. If this occurs, close the intelligent function
module utility first, and subsequently GX Developer (such as programs and
comments) and other applications. Then, restart GX Developer and the intelligent
function module utility.
(4) Activating intelligent function module utility
(a) PLC series set in GX Developer
A project must be specified. When creating a new project, select "QCPU (Q
mode)" for the PLC series in GX Developer.
If any series other than "QCPU (Q mode)" is selected, or if no project is specified,
the intelligent function module utility cannot be activated.
(b) Activation of multiple utilities
Multiple intelligent function module utilities can be activated.
Note, however, that "Open parameters" and "Save parameters" operations under
"Intelligent function module parameter" are allowed for one intelligent function
module utility only.
For the other utilities, only the "Monitor/test" operation is allowed.