Filter
Top Products
4 - 3
4.2 Procedures and Settings before System Operation
4
PROCEDURES AND SETTINGS BEFORE SYSTEM
OPERATION
4.2 Procedures and Settings before System Operation
Start
Wiring
Module mounting
Mount the Q68RD3-G in the specified slot.
Use user range settings?
Use factory default settings
Use user range settings
NO
YES
Use the utility package?
Programming and debugging
Create and check sequence programs.
Connect the RTD and the Q68RD3-G. When using a
relay terminal block, connect the RTD to the relay
terminal block and then connect the relay terminal block
to the Q68RD3-G.
(Refer to Section 4.4.2)
Intelligent function module switch setting
Make switch settings using GX Developer.
(See Section 4.5).
Offset/gain setting
When using user range settings, perform offset/gain
setting.
(See Section 4.6).
Initial setting and Auto refresh setting
Make these settings using the utility package to simplify
sequence programs.
(See Chapter 5).
(Refer to Section 4.4.2).
(Refer to Section 4.5).
(Refer to Section 4.6).
(Refer to CHAPTER 5).