Filter
Top Products
7
ONLINE MODULE CHANGE
7.3 Procedures of Online Module Change
7.3.2 When factory default is used and initial setting has been made with sequence program
7 - 9
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PROCEDURES AND
SETTINGS BEFORE
SYSTEM OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
7.3.2 When factory default is used and initial setting has been made with
sequence program
(1) Disabling conversion
(a) Set the Conversion enable/disable setting (Un\G0) to "Disable" for all channels
and turn Operating condition setting request (Y9) from OFF to ON to stop
conversion.
After confirming that conversion has stopped with the Conversion completion flag
(Un\G10), turn OFF Operating condition setting request (Y9).
(2) Removing a module
(a) On the screen displayed by selecting [Diagnosis] - [Online module change] in GX
Developer, select the "Online module change" mode and double-click the module
to be changed online to display the "Online module change" screen.