Filter
Top Products
5 - 2
5.1 Utility Package Functions
5
UTILITY PACKAGE (GX Configurator-TI)
Table 5.1 List of utility package (GX Configurator-TI) functions (2/2)
Function Description Reference
Monitor/test
Monitors and tests the buffer memory and I/O signals of the Q68RD3-G.
Section 5.6
•Module ready •Disconnection detection signal
•Operating condition setting completion flag •Warning output signal
•Operating condition setting request •Conversion completion flag
•Offset/gain setting mode status flag •Error flag
•User range write request •Error clear request
•Channel change completion flag •Mode switching setting
(1)
CH Monitor/test
•Conversion enable/disable setting •Rate alarm warning output enable/disable
setting
•Averaging processing selection •Rate alarm warning detection period
•Time/Count/Moving average/Time constant setting •Warning output flag (Rate alarm) lower
limit value
•Conversion completion flag •Warning output flag (Rate alarm) upper
limit value
•Measured temperature value •Rate alarm upper limit value
•Error code •Rate alarm lower limit value
•Setting range •Disconnection detection flag
•Process alarm warning output enable/disable setting •Scaling value
•Warning output flag (Process alarm) lower limit value •Scaling valid/invalid setting
•Warning output flag (Process alarm) upper limit value •Scaling range lower limit value
•Process alarm lower lower limit value •Scaling range upper limit value
•Process alarm lower upper limit value •Scaling width lower limit value
•Process alarm upper lower limit value •Scaling width upper limit value
•Process alarm upper upper limit value •Conversion setting for disconnection
detection
•Conversion setting value for
disconnection detection
(2) Offset/gain setting
•Mode switching setting
•CH Offset setting value
•Mode switching setting status
•CH Gain setting channel setting
•Conversion enable/disable setting
•CH Gain setting value
•Operating condition setting request •Channel change completion flag
•Setting range •Channel change request
•CH Offset setting channel setting •CH Measured temperature value
(3) X/Y Monitor/test
•Xn0: Module ready •Yn9: Operating condition setting request
•Xn9: Operating condition setting completion flag •YnA: User range write request
•XnA: Offset/gain setting mode status flag •YnB: Channel change request
•XnB: Channel change completion flag •YnF: Error clear request
•XnC: Disconnection detection signal
•XnD: Warning output signal
•XnE: Conversion completion flag
•XnF: Error flag
(4) OMC (Online Module Change) refresh data
•CH Factory default offset/gain values •CH User range settings offset/gain values
•CH User range settings resistance offset/gain values
•OMC (Online Module Change) refresh data
read request
•OMC (Online Module Change) refresh data write request