Filter
Top Products
2
SYSTEM CONFIGURATION
2.1 Applicable Systems
2 - 3
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PROCEDURES AND
SETTINGS BEFORE
SYSTEM OPERATION
5
UTILITY PACKAGE
(GX CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(b) Mounting to a MELSECNET/H remote I/O station
The table below shows the network modules and base units applicable to the
Q68RD3-G and quantities for each network module model.
Depending on the combination with other modules or the number of mounted
modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if the
power supply capacity is insufficient, change the combination of the modules.
:Applicable, :N/A
* 1 Limited within the range of I/O points for the network module.
* 2 Can be installed to any I/O slot of a base unit.
Remark
The Basic model QCPU or C Controller module cannot create the MELSECNET/
H remote I/O network.
Table 2.2 Applicable modules, number of mountable modules, and applicable base units
Applicable network
module
No. of modules
*1
Base unit
*2
Main base unit of
remote I/O station
Extension base unit of
remote I/O station
QJ72LP25-25
Up to 64
QJ72LP25G
QJ72LP25GE
QJ72BR15