Filter
Top Products
3 - 40
3.4 Buffer Memory
3.4.14 Disconnection detection flag (Un\G49)
3
SPECIFICATIONS
POINT
(1) Always set "Disable" for any channel where no RTD is connected.
If "Enable" is set, the bit of the corresponding channel in the Disconnection
detection flag (Un\G49) turns ON (changes to "1").
(2) When the Disconnection detection flag (Un\G49) turns ON (changes to "1"), a
value to be stored in the Measured temperature value can be selected from
"Up scale", "Down scale" or "Given value". (Refer to Section 3.2.2.)
When connection is restored, updating of the measured temperature value
will be restarted.
(3) For wiring of RTD, refer to Section 4.4.
(4) For troubleshooting of disconnection detection, refer to Section 8.2.7.