Filter
Top Products
3 - 42
3.4 Buffer Memory
3.4.16 Scaling valid/invalid setting (Un\G58)
3
SPECIFICATIONS
3.4.16 Scaling valid/invalid setting (Un\G58)
(1) This area is for setting the scaling function valid/invalid status for each
channel.
(2) The default value is set to "Invalid" for all channels.
(3) To activate the scaling function, turning ON/OFF Operating condition
setting request (Y9) after setting this area is required.
(4) Program example with a condition of the following is below.
Scaling range: -100 to 500 (lower limit value = -1000, upper limit
value = 5000)
Scaling width: 0 to 100% (lower limit value = 0, upper limit value = 100)
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH100000000
Data for b8 to b15 is fixed to "0".
0: Valid
1: Invalid
Sets CH1 scaling function to
"Enable".
Sets CH1 Scaling range lower
limit value.
Sets CH1 Scaling range upper
limit value.
Sets CH1 Scaling width lower
limit value.
Sets CH1 Scaling width upper
limit value.
Turns ON Operating condition
setting request (Y9).
Turns OFF Operating condition
setting request (Y9).
\
\
\
\
\