Filter
Top Products
5 - 23
CHAPTER5 MEMORIES AND FILES USED FOR CPU MODULE
1
2
3
4
5
6
7
8
5.1 Memories Used for CPU Module
5.1.8 Operating the program in the memory card (boot operation)
5.1.8 Operating the program in the memory card (boot operation)
This section describes methods for operating the program stored in the memory card.
(1) Operating the program in the memory card
To execute the boot operation, set the names of files to be booted in the Boot file tab of the PLC parameter dialog
box. ( (3) in this section, (4))
The program stored in the memory card, whose file name is specified in the Boot file tab, is booted with the
program memory after the CPU module is powered off and then on or is reset.
(2) Bootable files, transfer source, and transfer destination
Table Table5.5 provides the combinations of bootable file, transfer source, and transfer destination.
: Bootable, : Cannot be booted.
Figure 5.20 Boot operation
Table5.5 Combinations of bootable file, transfer source, and transfer destination
File name Transfer source
Transfer destination
Program memory Standard ROM
Parameter
Memory card
Sequence program
Device comment
Initial device value
Label program
CPU module
Memory card
Boot
Program
memory