Filter
Top Products
6 - 128
6.24 Service Processing
6.24.1 Service processing setting
(1) Definition
This function allows to set the time and the number of times of service processing performed at END processing
by parameters.
This function also improves the response of communication with a peripheral and restrains the increase of scan
time due to service processing.
This achieves the configuration of service processing environment optimum for the system.
The service processing refers to communication service processing with a peripheral (such as GX Developer) and intelligent
function modules. Link refresh processing such as CC-Link IE controller network module, MELSECNET/H module, and CC-
Link Safety system master/local module are not included.
Using the COM instruction enables service processing during program execution of same performance with
service processing at END processing. Therefore, the high-speed service processing response can be performed
even if the scan time is long.