Filter
Top Products
11 - 10
11.5 Procedure for Boot Operation
This section describes a procedure for boot operation.
In the following procedure, indicates an operation on the CPU module side.
Figure 11.4 Flowchart for boot operation
YES
NO
YES
NO
Section 5.1.8
Section 2.3
Section 5.1.7
Start (continued from
or )
If the RUN/STOP/RESET switch is in
RUN, set the switch to STOP.
Set the file name of parameters, a
program, devices, initial values and
device comments in the Boot file tab
of the PLC parameter dialog box.
Set the names and execution conditions of
programs to be executed in the Program tab
of the PLC parameter dialog box (This setting
is necessary when one program is written).
Use the memory
card (except the
Flash card)?
Select [Online] [Format PLC memory]
in GX Developer and format the
program memory.
Select [Online] [Write to PLC (Flash ROM)]
[Write to PLC (Flash ROM)] "Program
memory/Device memory" for "Target
memory" in GX Developer and write the
parameters and created programs.
Power off the programmable controller
and then on or reset the CPU module.
Is the BOOT LED on?
End
GX Developer Version 8 Operating Manual
Section 11.3
Section 11.4