Filter
Top Products
App - 2
(To the next page)
TableApp.1 List of parameter numbers (continued)
Item Parameter No. Reference
Use serial communication
100E
H
Section 6.23, Section
8.1(11)
Transmission speed
Sum check
Transmission wait time
RUN write setting
Service processing setting 1013
H
Section 6.24.1, Section
8.1(2)
Latch data backup operation valid contact 1014
H Section 6.28, Section 8.1(2)
File register 1100
H Section 9.7, Section 8.1(3)
Comment file used in a command 1101
H Section 8.1(3)
Initial Device value 1102
H Section 6.25, Section 8.1(3)
File for local device 1103
H
Section 9.14.2, Section
8.1(3)
Transfer to Standard ROM at Latch data backup operation 1104
H Section 6.28, Section 8.1(3)
File used for SP.DEVST/S.DEVLD instruction 1105
H Section 6.29, Section 8.1(6)
Device points 2000
H Section 9.1, Section 8.1(6)
Latch (1) start/end 2001
H
Section 3.4, 6.3, Section
8.1(3)
Latch (2) start/end 2002
H
Local device start/end 2003H
Section 9.14.2, Section
8.1(6)
File register extended
setting
Device points
2000
H
Section 9.8, Section 8.1(6)
Latch (1) start/end
2004
H
Latch (2) start/end
2005
H
32 bit Indexing 2000H Section 8.1(6)
WDT (watchdog timer)
setting
WDT setting
3000
H
Section 6.16, Section 8.1(4)
Initial execution monitoring time
Section 2.3.1, Section
8.1(4)
Error check
Carry out battery check
3001H
Section 6.17, Section 8.1(4)
Carry out fuse blown check
Verify module
Check device range at indexing
Diagnose redundant power supply system
Operating mode when
there is an error
Computation error
3002
H
Expanded command error
Fuse blown
Module verify error
Intelligent module program execution error
File access error
Memory card operation error
External power supply OFF
Constant scanning 3003
H Section 6.2, Section 8.1(4)
Module error collection setting 300A
H Section 6.32, Section 8.1(5)
Detailed setting
H/W error time PLC operation mode 4004H Section 6.9, Section 8.1(10)