Filter
Top Products
3 - 11
*1: The remote input refresh area indicates the area to be used when auto refresh is set to the input (X) in the
CC-Link IE controller network, MELSECNET/H, or CC-Link.
Data in the remote input refresh area will be refreshed automatically during END processing.
*2: Data in the GX Developer input area can be turned on/off by the following operation.
•Test operation by GX Developer
•Writing data from a network module
*3: Data in the output (Y) device memory can be turned on/off by the following operation.
•Test operation by GX Developer
•Refresh via CC-Link IE controller network or MELSECNET/H
•Writing data from an external device using the MC protocol
•Auto refresh via CC-Link
(4) Response delay
An output response which corresponds to the status change in the input module delays for two scans
(maximum) depending on the on timing of an external contact.
Examples
Figure 3.4 Y5E turns on the earliest
Figure 3.5 Y5E turns on the latest
55
X5
Y5E
A program that turns on the output
Y5E when the input X5 turns on.
Delay time
(Minimum 1 scan)
OFF
ON
0 END END00
: Input refresh
56
External contact
OFF
ON
X5
OFF
ON
Y5E
OFF
ON
External load
Devices in the
CPU module
: Output refresh
Delay time
(Maximum 2 scans)
OFF
ON
0 END END00
: Input refresh
56
External contact
OFF
ON
X5
OFF
ON
Y5E
OFF
ON
External load
Devices in the
CPU module
: Output refresh