Filter
Top Products
1
2
3
APPEN-
DIX
6
7
8
Appendix 1 List of Parameter Numbers
APPENDICES
App - 1
APPENDICES
Appendix 1 List of Parameter Numbers
Each parameter number will be stored in the special register (SD16 to SD26) when an error occurs in the
parameter settings.
TableApp.1
lists the parameter items and corresponding parameter numbers.
For explanation of M and N shown in the "Parameter No." column, refer to Section 8.2.
(To the next page)
TableApp.1 List of parameter numbers
Item Parameter No. Reference
Label 0000H
Section 8.1(1)
Comment 0001H
I/O assignment
Type
0400
H Section 4.2.2, 8.1 (9)
Model name
Points
Start XY (Start I/O number)
Base setting
Base model name
0401
H Section 4.2.1, Section 8.1(10)
Power model name
Extension cable
Slots
Detailed setting
Error time output mode 0403H Section 6.8, Section 8.1(10)
I/O response time 0405H Section 6.8, Section 8.1(10)
Control PLC 0406H
Section 8.1 (9),
QCPU User’s Manual (Muitiple
CPU System)
No. of PLC 0E00
H
Section 8.1 (12),
QCPU User’s Manual (Muitiple
CPU System)
Operating mode
0E01H
I/O sharing when using
Multiple CPUs
All CPUs can read all inputs
0E04
H
All CPUs can read all outputs
Timer limit setting
Low speed
1000
H Section 8.1(2)
High speed
RUN-PAUSE contacts
RUN
1001
H
Section 6.6.1, Section 8.1(2)
PAUSE Section 6.6.2, Section 8.1(2)
Remote reset 1002
H Section 6.6.3, Section 8.1(2)
Output mode at STOP to RUN 1003
H Section 6.4, Section 8.1(2)
Common pointer No. 1005
H Section 9.10.2, Section 8.1(2)
Points occupied by empty slot 1007
H Section 4.4.2, Section 8.1(2)
Interrupt program/Fixed scan program setting
1008H
Section 2.2.3, 2.3.4, 8.1 (2)
System interrupt settings Fixed scan interval (n : 28 to 31) Section 8.1(2)
Intelligent function module setting (Interrupt pointer setting) 100A
H Section 9.11, Section 8.1(2)
Module synchronization 100C
H Section 8.1(2)