Filter
Top Products
142 C624M-C (5/06)
Configuring Advanced Video Loss-Activated Relay Output
To configure an advanced video loss-activated relay output:
1. On the DX8000 toolbar, click . The Setup dialog box opens to the Camera page.
2. In the Setup dialog box, click . The Schedule page is displayed.
3. Click the Configure Relays button. The Configure Relays dialog box opens.
4. Click the Video Loss tab if it is not already selected.
5. Configure each relay that is linked to an alarm:
a. Click the drop-down box to select a relay.
b. Select a relay timing value from the Activation Period drop-down box.
Figure 107. Linking Relays to Video Loss
The following table describes the available options.
Table AL. Video Loss-Activated Relay Settings
Option Result
Disable Relay will not activate when a video loss event occurs.
Follow Event Relay will activate at the exact same time the video loss event happens.
1, 3, 5, 10,15, and 20 Seconds Sets the amount of time the relay will remain active after the video loss event occurs.
ᕤ
5a
5a
5
b