Filter
Top Products
C624M-C (5/06) 153
Using Custom Device Filters
The DX8000 allows you to use a custom device filter to remove unwanted characters from the data input port. These characters may be printer
commands or some other type of device control/overhead. Each entered line of text in the Custom Device Filter table defines a separate
character filter. A filter can be a combination of exact characters to match, character ranges to match, and character counts. Incoming characters
matching any of the character filters will be discarded.
Use the Control Code drop-down box, Special Character drop-down box and Range text box to create the desired filter, and then transfer the
created filter to the Custom Device Filter table by clicking the Add button.
Creating a New Data Format
You create the data format based on information contained in the ATM/POS transaction. For example, a sales receipt provides detailed
transaction information. The data format values determine how data from ATMs or POS terminals is interpreted. This information is used to
separate the data stream into individual transactions and separate the various fields within the transaction. Every field format must match that of
the ATM or POS device, especially the month format.
To create a data format:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port Configuration section, click Configure. The Device Configuration page is displayed.
3. In the selected device drop-down box, select an ATM/POS device.
4. Click the Data Format tab.
5. In the Data Format page, click Add. The Data Format dialog box opens.
6. Using the information from the transaction record or other source, set the parameters for the following Data Format sections (as applicable):
• Transaction Format
• Monetary Format
• Time Format
• Character Format
7. Click OK.
8. Verify that the new data format is listed in the Data Format List on the Data Format page.
Editing a Data Format
The DX8000 allows you to edit a data format. Once you click OK to accept the changes, you cannot undo the changes.
To edit an existing data format:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port Configuration section, click Configure. The Device Configuration page is displayed.
3. In the Data Format List, highlight the name of a data format.
4. Click Edit. The Data Format dialog box opens.
5. Verify that the name of the data format you want to edit is displayed in the Data Format Name text box.
6. Perform the edits.
7. Do one of the following:
• To accept the changes, click OK.
• To not accept the changes, click Cancel.
Deleting a Data Format
To delete an existing data format:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port Configuration section, click Configure. The Device Configuration page is displayed.