Filter
Top Products
158 C624M-C (5/06)
7. In the Exceptions dialog box, do the following:
a. In the Exception Name text box, enter a name or description for the exception (up to 20 characters).
b. In the Line Item text box, enter the name of the line item (up to 20 characters). The line item entry is case-sensitive. In this case, if the
transaction is displayed as all capital letters, then the line item entry must be in all capital letters.
The DVR will search for this entry anywhere in the transaction. ATM transactions do not usually contain line items. The program may
display a “No data found” error message if searching ATM transactions using line items. If the line item box is left blank, it is
considered found or satisfied.
c. In the Modifier drop-down box, select a modifier that further defines the line item.
A modifier must be selected before a value can be entered. If a modifier is not selected, the Value text box is unavailable.
d. In the Value box, enter the value.
The value (9999.99 maximum) is used with the modifier (above) to trigger an exception. You can use a period to separate dollars and
cents, but do not use a comma between thousands and hundreds.
e. In the This Exception Effect section, do one of the following:
• Accept the default display effect setting.
• In the Display Effect drop-down box, select Don’t Show or Show.
8. Click OK.
9. At the Advanced page, do one of the following:
• Click Apply to confirm selection and remain in the Device Configuration dialog box.
• Click OK to confirm selection and return to the Port/Device page.
Editing an ATM/POS Exception
To edit an ATM/POS exception:
1. In the Network page, click the Port/Device tab. The Port/Device page is displayed.
2. In the Communication Port Configuration section, click Configure. The Device Configuration dialog box is displayed.
3. Click the Advanced tab. For information on the Advanced page, refer to Setting Up ATM/POS Exceptions on page 155.
4. In the Exception Table, select an exception.
5. Click Edit. The Exceptions dialog box opens.
6. Edit the exception content.
7. Do one of the following:
• Click OK to accept the changes and exit the Exceptions dialog box.
• Click Cancel to exit the Exception dialog box and not save changes.
Table AT. ATM/POS Exception Modifiers
Modifier Description
None Value to the right is not used and is disabled.
> Greater than: Trigger exception only if the value found on the line is greater than the value entered in the
Value text box.
< Less than: Trigger exception only if the value found on the line is less than the value entered in the Value
text box.
= Equal to: Trigger exception only if the value found on the line is equal to the value entered in the Value
field.
!= Not equal to: Trigger exception only if the value found on the line is not equal to the value entered in the
Value field.