Pelco C624M-C (5/06) DVR User Manual


 
C624M-C (5/06) 167
6. (Optional) In the Device Selection section, to map a network drive for backup, do one of the following:
a. Click the “Map a network drive” button to map a network drive. The Windows Map Network Drive dialog box opens. For more
information about mapping a network drive, refer to Mapping a Network Device on page 169.
(1) Specify the drive letter for the connection and the folder that you want to connect to.
(2) Click Finish. The mapped drive is displayed in the Device Selection area under “Remote drives.”
or
b. Click Disconnect a mapped drive” to disconnect a mapped drive.
7. In the Device Selection section, click the check box for the device you want the data to be backed up to.
8. Click OK.
The “Backup schedule” table is displayed and the newly scheduled backup time range is listed in the table and the selection check box is
marked.
EDITING AN EXISTING BACKUP SCHEDULE
The DX8000 allows you to edit or delete an existing backup schedule.
To edit a backup schedule:
1. On the DX8000 toolbar, click . The DX8000 setup screen is displayed.
2. Click . The backup configuration screen is displayed.
3. In the “Backup schedule” table, do the following:
a. Click the backup schedule time range you want to edit.
b. Click Edit.
The Edit Backup Schedule dialog box opens, displaying the current settings for the selected backup schedule.
Figure 120. Editing an Existing Backup Schedule
c. Edit the backup parameters.
d. Click OK.
The Edit Backup Schedule dialog box closes, and the backup configuration screen is displayed. The updated schedule details are
displayed in the “Backup schedule” table.
4. Click Apply.