Filter
Top Products
C624M-C (5/06) 197
Appending an Existing Sequence List
To append an existing sequence list to the current list:
1. On the DX8000 toolbar, click . The Setup dialog box opens to the Camera page.
2. Click . (This icon appears only if the optional MUX display card is installed.) The External Output page is displayed.
3. Click Load. The “Load profile” dialog box opens.
4. Select a profile.
5. Click OK.
The “Append to list” dialog box opens.
6. Click Yes to add the new sequences to the existing list.
7. To add, delete, or modify sequence instances follow the directions in the sections above.
8. Click Save.
9. Select an existing profile or enter a new profile name to save the sequence list.
10. Click OK.
11. Click Apply in the Sequence Table section.
12. Click Apply.
CONFIGURING DISPLAY OVERRIDE
The MUX display card can be configured to interrupt normal output when a motion or alarm event is detected. Each event instance causes live
video from the sensing camera to be displayed for up to sixty seconds after event detection.
To set up event monitor override options:
1. On the DX8000 toolbar, click . The Setup dialog box opens to the Camera page.
2. Click . (This icon appears only if the optional MUX display card has been installed.)
3. Select the type of event that will be allowed to override the monitor output:
• Alarm input
• Motion detection
4. Set the dwell time an event will be allowed to override the screen (1-60 seconds).
5. Click Apply.
USING THE EXTERNAL MONITOR OPTION
To assign a sequence profile to an external analog monitor:
1. On the DX8000 toolbar, click .
2. On the DX8000 toolbar, click .
The External Monitor drop-down menu is displayed.
3. Select a profile from the External Monitor drop-down menu.