Filter
Top Products
192 C624M-C (5/06)
To configure the second (bottom) output on the display card for automatic camera mapping:
1. On the DX8000 toolbar, click . The Setup dialog box opens to the Camera page.
2. Click . (This icon appears only if the optional MUX display card has been installed.) The External Output page is displayed.
3. In the Auto Camera Mapping Mode section, do the following:
a. Select the Auto Camera Mapping Mode radio button.
b. Select of the screen division options.
c. Select dwell time (1 to 60 seconds) from the drop-down box. This is the amount of time each window will remain on the monitor.
d. Select the type of event that will be allowed to override the monitor output:
• Alarm input
• Motion detection
e. Set the dwell time an event will be allowed to override the screen (1-60 seconds).
4. Click the Apply button at the bottom of the page.
Figure 134. External Monitor – Automatic Mapping
Setting Up Manual Camera Mapping
Manual camera mapping allows a user to customize the MUX display card output. Individual cameras can be assigned to view panels in any
combination. Each customized screen can be added to a sequence list and assigned a specific amount of dwell time. These combinations of
customized screens and corresponding dwell times make up sequence instances. Multiple sequence instances can be combined into a sequence
list. The resulting list will sequentially display each instance on an external monitor in a continuous loop. The sequence will continue
uninterrupted until an alarm or motion event overrides the cycle.
The manual camera mapping feature has the following stipulations:
• Eight-channel DVRs offer only the 1x1, 2x2 and 3x3 view panel options.
• If you select more than one screen division, each camera channel will cycle through each screen before the next panel division is presented.
This section describes how to set up manual camera mapping and includes the following topics:
• Creating Monitor Sequence Instances on page 193
• Loading an Existing Sequence List on page 194
• Modifying a Sequence Instance in the List on page 195
• Deleting a Sequence Instance from the List on page 196
• Appending an Existing Sequence List on page 197
3
b
3c
3e
3a
3
d