Filter
Top Products
C624M-C (5/06) 55
CONFIGURING PRESET TOURS
A preset tour allows a camera to move through a programmed sequence of PTZ presets. The DX8000 Series DVR can store up to four preset
tours. While four tours can be programmed, only one tour can be activated at a time. A preset tour will operate continuously until another PTZ
control action is performed. At least one PTZ preset must be set in order to create a preset tour.
The PTZ controls are hidden in the extended view mode. In this case, select the standard view mode to display the PTZ controls.
To switch between the standard and extended view mode:
This section describes how to configure preset tours and includes the following topics:
• Programming a Preset Tour on page 55
• Activating a Preset Tour on page 58
• Deactivating a Preset Tour on page 58
PROGRAMMING A PRESET TOUR
This section describes how to program a preset tour and includes the following topics:
• Accessing a Preset Tour Group on page 55
• Adding Presets to a Tour on page 56
• Deleting Presets from a Tour on page 57
Accessing a Preset Tour Group
To access the “Preset tour group” dialog box:
1. On the DX8000 toolbar, click .
2. On the DX8000 keypad, click and then on the PTZ keypad. The Preset tour group dialog box opens.
3. Select the preset tour (1-4) that you want to program from the drop-down box.
4. Do one of the following:
• To add presets to a tour, refer to Adding Presets to a Tour on page 56.
• To delete presets from a tour, refer to Deleting Presets from a Tour on page 57.
Figure 31. Preset Tour Dialog Box
From the DX8000 menu bar, choose View > Extended View.
ᕣ