Filter
Top Products
194 C624M-C (5/06)
Loading an Existing Sequence List
To load an existing sequence list:
1. On the DX8000 toolbar, click . The Setup dialog box opens to the Camera page.
2. Click . (This icon appears only if the optional MUX display card has been installed.)
3. In the Manual Camera Mapping Mode section, do the following:
a. Click the radio button to select the Manual Camera Mapping mode.
b. Click Load to load or modify an existing sequence.
The “Load profile” dialog box opens.
c. Select a profile.
d. Click OK.
The DX8000 dialog box opens prompting you to append the sequence to the list.
e. Click No to the Append option.
Figure 136. Loading a Mapping Sequence
3c
3a
3a
3
d
3
b