Filter
Top Products
‘able
5-4. Functional Index (continued)
Function
Command
Corresponding
Description
Category
Key Function
CONFIGURATION
PREFX
Change Prefix
Specifies or changes the
prefix
used in
[continued)
save and recall operations.
PRNPRT
PRN PORT HPIB PAR
Directs the printer output to HP-IB or
parallel ports for Option 041.
PRNPRT
PRN
PORT
SER
PAR
Directs the printer output to RS-232 or
parallel ports for Option 043.
SETDATE
SET DATE
Sets the date of the real-time clock.
SETTIME
SET TINE
Sets the time of the real-time clock.
SYNCMODE
SYNC
NM
NTSC ,
Selects either the horizontal and vertica
DEF’ABLT
SYNC,
synchronizing constants, or the
synchronization rate for the internal
SYNC
NRN
PAL
monitor.
TIMEDATE
Sets the time and date of the real-time
clock.
TIMEDSP
TINNDATE ON OFF
Turns on or off the display of the
real-time clock.
DISPLAY
ANLGPLUS*
ANALOG+ ON OFF *
Turns the Analog+ display mode on or
Off.
ANNOT
ANNOTATN ON
OFF
Turns on or off the screen annotation.
DA
Accesses the current address of the
display list.
DL
DSP LINE ON OFF
Defines the level of the display line
in
the active amplitude units and displays
the display line on the spectrum
analyzer screen.
DOTDENS*
ANALOG+ ON OFF *
Sets the dot density value in the
Analog+ display mode.
DSPLY
Displays the value of a variable on the
spectrum analyzer screen.
GRAT
MAT
OK
OFF
Turns on or off the graticule.
HD
HOLD or
IHOLD)
Disables data entry via the spectrum
analyzer numeric keypad, knob, or step
keys. The active function readout is
blanked, and any active function is
deactivated.
MENU
Displays speclfled menu on the
spectrun
analyzer screen.
PREFX
Change Prefix
Specifies the prefix.
TH
TARESNLD
ON OFF
Clips signal responses below the
threshold level.
TITLE
Change
Title
Activates the screen title mode.
TREQUENCY
CF
CENTER
FREQ
Specifies center frequency.
FA
START
FREQ
Specifies the start frequency.
FB
STOP
FREfJ
Specifies the stop frequency.
FOFFSET
FNEQ
OFFSET
Specifies the frequency offset for all
absolute frequency readouts such as
center frequency.
ss
CF
STEP
&WI’0
NAN
Specifies center-frequency step size.
’
For Option 101 or 301 only.
5-14 Programming Commands