Filter
Top Products
LOAD Load
File name: You must supply the file name of the file to be loaded. When specifying the file
name, be sure to include the lowercase letter that indicates the data type, because the result
of the LOAD operation is dependent on the data type. (For example, the “d” in
“dM-YPROG”
indicates the file type is for a downloadable program.) The lowercase letters correspond to the
data type as shown in the following table.
File Description
I
Result
I
a
Amplitude correction
Loads the amplitude correction factors.
factors
I
i
Display image file Loads and displays the display image
file.
d Downloadable Loads the contents of the file that was stored with STOR. Because
program STOR stores a copy of user-memory in the file, more than one item
may be retrieved when executing the LOAD command.
I
1
I
Limit lines
I
Loads the limit-line values into the current limit-line table.
I
Loads the spectrum analyzer state, and changes the current spectrum
analyzer state to the state that was loaded.
ItJT.race
1
Loads the trace and state. The current spectrum analyzer trace and
state is changed to the trace and state that was loaded.
Destination: When recalling trace data, you need to specify either TRA, TRB, TRC, or
a user-defined trace as the destination. Omit the destination parameter when recalling
downloadable programs, states, limit-line tables, display image files, or amplitude correction
factors.
Note
The LOAD command recalls data from the memory card. See “SAVRCLN,
n
“RCLT,
”
or “RCLS” to recall data from spectrum analyzer memory.
Programming Commands
5-297