ZMKSPAN Zone Marker Span
ZMKSPAN
Zone Marker Span
Changes the width of the zone marker.
Syntax
XZMKSPAN
I
Item
Description/Default
!
Range
Number
Any real or integer number. Default unit is Hz.
0 to maximum
frequency
span of the
I
Equivalent
Softkey
(HP 85913, HP 85933, HP 85943, HP 85953, or HP 85963 only):
ZOESE
SPAN.
Default value: l/10 of the spectrum analyzer’s frequency span.
Related Commands: SP,
WINON,
ZMKCNTR.
Example
OUTPUT
718;"WINON;"
Turns on the windows display
mode.
OUTPUT
718;"ZMKSPAN
IOOMHZ;"
Sets the span of the zone marker to 100 MHz
Description
ZMKSPAN allows you to change the frequency span of the zone marker that is displayed in
the upper window. When the lower window is the active window, frequency span (SP) of the
lower window changes the frequency span of zone marker in the upper window.
Restrictions:
Use ZMKSPAN only if the window is in non-zero span; ZMKSPAN does not apply
if the window is in the time domain. ZMKSPAN should only be used when the windows display
mode is turned on.
Programming Commands 5603