Filter
Top Products
GDRVST
Couple Sweep Time to Pulse Repetition Interval
Couples or uncouples the sweep time to the pulse repetition interval
Syntax
uncoup
I ed
.._._..’
coupled
/
\
XGDRVST
Equivalent
Softkey:
CPL
SWP
ON OFF.
Option Required: Option 105. Option 101 is recommended.
Preset Value: Uncoupled.
Related Commands: GDRVPRI.
Example
OUTPUT
718;"MOV
GDRVST,l;"
Couples the sweep time to the pulse repetition interval.
Description
Before coupling the sweep time to the pulse repetition interval, you should enter the pulse
repetition interval into GDRVPRI. Coupling the sweep time to the pulse repetition interval
updates the trace display in the active window. If the sweep time and the pulse repetition
interval are uncoupled, the setting of the sweep time does not change.
The sweep time is 401 times the pulse repetition interval when coupled. The sweep time is
updated to
the
coupled value when the window is next active.
You can execute the GDRVST command two different ways. You can either execute the
GDRVST command directly (for example,
"GDRVST
1;
I’)
or use the MOV command to move
the 1 or 0 into the GDRVST command (for example,
"MOV
GDRVST, 1;
'I).
If you use the MOV
command, no text is displayed in the active function area during command execution.
The GDRVST command is a gate utility function (see “GDRVUTIL” for more information about
the gate utility functions). Executing a gate utility command without Option 105 installed in
the spectrum analyzer generates the
COMMAND ERROR:
message and an SRQ 140.
5-206 Programming Commands