Filter
Top Products
SYNCMODE
Synchronize Mode
The following parameters for
SYNCMODE
are described:
NORMAL
NTSC15
Restores the previous values for the horizontal and vertical synchronizing
constants of the spectrum analyzer display if
SYNCMODE
NTSC15 or
SYNCMODE
PAL15 was previously executed. The previous values for the
horizontal and vertical position are the positions that were set by CRTHPOS
and CRTVPOS.
SYNCMODE
NORMAL is equivalent to SYNC
MRM
NTSC (with
NRM underlined).
Selects the NTSC format for a spectrum analyzer that has an internal monitor
with a
horizontal
scanning rate of 15.75 kHz (the monitors for the HP
859OL,
HP 85913, HP
8592L,
HP 85933, HP 85943, HP 85953, and HP 85963 all have
horizontal scanning rates of 15.75
kHz).
SYNCMODE
NTSC15 is equivalent to
SYK!
NRM
NTSC (with NTSC underlined).
PAL15
LOAD15
Selects the PAL format for a spectrum analyzer that has an internal monitor
with a horizontal scanning rate of 15.75
kHz
(the monitors for the HP
859OL,
HP 85913, HP
8592L,
HP 85933, HP 85943, HP 85953, and HP 85963 all have
horizontal scanning rates of 15.75
kHz).
SYNCMODE
PAL15 is equivalent to
SYI?C
NRM
PAL (with PAL underlined).
Loads the default
constants
horizontal and vertical position for the display
of a spectrum analyzer with an internal monitor with 15.75
kHz
horizontal
scanning (the HP
859OL,
HP 85913, HP
8592L,
HP 85933, HP 85943,
HP 85953, and HP 85963 all have horizontal scanning rates of 15.75
kHz).
The default constants are the constants that are stored into the spectrum
analyzer’s read-only memory (ROM).
SYNCMODE
LOAD15 is equivalent to
RRFAUI,T
SYNC .
When used as a predefined variable,
SYNCMODE
returns a number from 0 to 5. The value that
is returned by
SYNCMODE
depends on the
SYNCMODE
parameter, as shown in the following
table.
Programming Commands 5-541