Filter
Top Products
‘Ihble
5-4. Functional Index (continued)
Function
Command
Corresponding
Description
Category
Key Function
MARKER
(continued) PKSORT
PK SORT
FRQ
AI@
Selects how the signal peaks listed in
the peak table are sorted: by
decreasim
amplitude or by ascending frequency.
PKTBL
PK
TABLE ON OFF
Turns on or off the peak table.
YIATH
(see also
ABS
Places the absolute value of the source
l’race
Math)
values in the destination.
ADD
Adds the sources and sends the sum to
the destination.
AVG
Averages the source and the destination
BIT
Returns the state of a bit.
CTA
Converts the source values from
measurement units to the current
absolute amplitude units and stores the
result in the destination.
CTM
Converts the source values to
measurement units and places the
resuli
in the destination.
DIV
Divides source 1 by source 2 and places
the result in the destination.
EXP
Places the exponential of the source in
the destination.
INT
Places the greatest integer that is less
than or equal to the source value into
the destination.
LOG
‘lakes the logarithm (base 10) of the
source, multiplies the result by the
scaling factor, then stores it in the
destination.
MEAN
Returns the mean value of the given
trace
ln
measurement units.
MEANTH
Returns the mean value of the given
trace above the threshold, in
measurement units.
MIN
Compares source 1 and 2, point by
point, and stores the lesser of the two
in
the destination.
MINPOS
Returns a value, which
is
the s-axis
position (in display units) of the
MOD
minimum amplitude value in trace A,
trace B, trace C, or user-defined trace.
Stores the remainder from the division
of source
1
by source 2 in the
destination.
MPY
MXM
PDA
Multiplies the sources, point by point,
and places the results in the destination.
Compares source
1
and source 2, point
by point, sending the greater value of
each comparison to the destination.
Sums the probability distribution of
amplitude in the destination trace with
the amplitude distribution function of
the source trace.
PDF
Increments an element of the
destination trace whenever the
corresponding element of the source
trace exceeds a threshold.
Programming Commands
5-l
9