Filter
Top Products
GDRVREFE
Enter Reference Edge
Allows you to enter the position (in time) for a reference edge.
Syntax
GDRVREFE
‘._._.’
/
XGDRVREFE
Item Description/Default
Range
Number
Any real or integer number. Default unit is
p.s.
Range is from the sweep delay
(GDRVSWDE) plus the sweep time to the
I
I
sweep delay.
I
Equivalent Softkey: ENTER
REF
EDGE .
Option Required: Option 105. Option 101 is recommended.
Initial Value: 0 s.
Related Commands: GDRVUTIL.
Example
OUTPUT
718;"MOV
GDRVREFE,lMS;"
Description
Unlike ENTER REF EDGE , GDRVREFE does not make the marker function active or display the
Enter
REF
EDGE softkeys.
Once you enter a value into GDRVREFE, that value is retained until you change it, or execute
DISPOSE ALL. Pressing
@?Z’Z7]
or turning the spectrum analyzer off does not change the
value of GDRVREFE.
You can execute the GDRVREFE command two different ways. You can either execute the
GDRVREFE command directly (for example,
"GDRVREFE
1MS
;
‘I)
or use the MOV command
to
move
the value into the GDRVREFE command (for example,
“MOV
GDRVREFE,
1MS;
‘I).
If
you use the MOV command, no text is displayed in the active function area during command
execution.
The GDRVREFE command is a gate utility function (see “GDRVUTIL” for more information
about the gate utility functions). Executing a gate utility command without Option 105
installed in the spectrum analyzer generates the COMMAND ERROR: message and an SRQ 140.
5-204
Programming Commands