Filter
Top Products
IP Instrument Preset
MS1
NDB
PD
PKDLMODE
PKSORT
PKTBL
PKZOOM
QPOFFSET
RB
RL
RLPOS
ROFFSET
RQS 40
SPEAKER
SQLCH
SRCALC
SRCNORM
SRCPSWP
SRCPWR
ss
STATUS BYTE
TH
TITLE
TM
TDF
TRB
TRC
TVLINE
TVSYNC
VAVG
VB
VBR
Selects the spectrum analyzer memory as the mass storage device.
Sets the number of
dB
for the NDBPNT measurement to -3
dB.
Puts pen down at current position.
Displays all the signal peaks in the peak table.
Sorts the signal peaks in the peak table by decreasing amplitude.
Turns off the peak table.
Sets the final span for the peak zoom routine to 1 MHz.
Sets the QPOFFSET to 20. (Option 103 only.)
Sets the resolution bandwidth to 3 MHz.
Sets reference level to 0
dBm.
Sets the reference level position to 8.
Sets reference offset to 0.
Allows SRQ 110, SRQ 140 for illegal commands or broken hardware.
Turns on the speaker. (Option 102, 103, or 301 only.)
Sets the squelch level to 0. (Option 102 or 103 only.)
Sets the source leveling control to internal. (Option 010 or 011 only.)
Sets the source normalization to off. (Option 010 or 011 only.)
Sets the source power sweep to off. (Option 010 or 011 only.)
Sets the source power level to -10
dBm.
(Option 010 or 011 only.)
Sets the center frequency step size to 100 MHz.
Clear the status byte.
One division above bottom graticule line, threshold line off.
Clears the title from the spectrum analyzer screen.
Selects free run trigger mode.
Selects parameter units output format.
Sets the trace values to 0.
Sets the trace values to 8000.
Sets TV line number to 17. (Options 101 and 102, or 301 only.)
Triggers on negative polarity of the video modulation. (Options 101
and 102, or 301 only.)
Turns off video averaging and sets the video averaging limit to 100.
Sets the video bandwidth to 1 MHz.
Sets VBR to 0.300.
5-244 Programming Commands