Administer Communication Manager
Issue 9.1 June 2006 173
Administer Communication Manager
!
Important:
Important: The administration procedures in this section are performed manually in a SAT
session on the media server that is the primary controller for the new G700 you
previously installed. This primary controller may or may not be the S8300 you
installed in the G700.
The primary controller for the G700/S8300 you are installing must be administered to enable
communication between the primary controller and the G700/S8300. The administration differs
somewhat depending on whether the primary controller is an S8300 or the primary controller is
an S8400, S8500, or S8700-series Media Server.
When the primary controller is an S8300, it could be:
● The S8300 you previously installed
● A separate, possibly remote, S8300.
In the first case, the G700/S8300 you installed is a standalone (or “ICC”) configuration. In the
second case, the S8300 you installed is configured as an LSP.
Perform one of the following two administration procedures in this section:
● Administering an S8300 primary controller
● Administering an S8400, S8500, or S8700-series primary controller
Administering an S8300 primary controller
!
CAUTION:
CAUTION: This administration applies only to the primary controller. If the S8300 you
installed is configured as an LSP, do not perform this administration on it.
Translations are automatically copied to the LSP from the S8300 primary
controller.
Skip this section and go to Administering an S8400, S8500, or S8700-series primary
controller on page 180 if the primary controller is an S8400, S8500, or S8700-series Media
Server.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of administration required, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.