Filter
Top Products
Administer Communication Manager
Issue 9.1 June 2006 221
Figure 21: Add Local Survivable Processor screen
4. The type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
5. Enter a network region for the LSP. The default is 1. However, there may be a different
network region better suited for the LSP to provide media gateway and IP phone support.
Administering the Media Gateway
To perform the procedures in this section, telnet to the primary controller, log in, and open a SAT
session.
!
CAUTION:
CAUTION: Before administering a media gateway, make sure that the gateway has been
fully configured.
In this section, you will do the procedures:
● To add a media gateway
● To verify changes
● To enable announcements, if necessary
● To save Communication Manager translations
To add a media gateway
1. At the SAT prompt, type add media-gateway <number>
where <number> is the gateway number from 1 to n. (n is 50 for an S8300, 5 for an S8400,
and 250 for an S8500 or S8700-series Media Server).
The Media Gateway screen appears.
add survivable-processor sv-mg2-lsp Page 1 of xx
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1