Filter
Top Products
Install New Firmware on the G700
Issue 9.1 June 2006 513
Show MG list_config
6. In the TYPE column, find the particular media module (v1 through v4), then check the
matching field in the FW VINTAGE column to see if it matches the planning documentation.
Note:
Note: Slot V1 can contain either a media module or the S8300, which will show as
TYPE ICC.
7. Check the VOIP FW column and row for slot v0 to see if the number matches the VoIP
firmware identified in the planning documentation.
8. Type reset <module #>
where <module #> is the number of the G700 in the stack.
9. When the reset is finished, type show mm to verify the upgrade.
To release board (if media module was busied out)
1. When the upgrade procedure is complete, go to the SAT session and release the board
Type release board vx
where x is the slot number of the upgraded media module.
2. Verify the response,
Command Successfully Completed
Note:
Note: If you see the response, Board Not Inserted, this means that the media
module is still rebooting. Wait one minute and repeat the release board
command.
3. Repeat the release board command for each media module that was busied out.
SLOT TYPE CODE SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------ ----- ------ ---------- ---------- -------
V0 G700 DAF1 A 00 21.25.0(A) 26
V1 ICC S8300 A 00 5 N/A
V2 DCP MM712 A 2 5 N/A
V3 ANA MM711 A 3 16 N/A
V4 DS1 MM710 A 1 8 N/A