Filter
Top Products
Administer Communication Manager
Issue 9.1 June 2006 523
In this section, you will use the SAT interface on the primary controller to:
● Assigning Node Names and IP Addresses for the C-LANs and LSPs
● Administering Network Regions
● Assigning LSPs to the Network Regions
● Administering IP Interfaces
● Identifying the Survivable Processor on the primary controller
Note:
Note: For information on installing the CLAN boards on the S8400, S8500, or
S8700-series port networks and complete information on installing an S8400,
S8500, or S8700-series Media Server, see the Installation documentation on the
Documentation for Avaya Communication Manager, Media Gateways and
Servers CD, 03-300151.
Assigning Node Names and IP Addresses for the C-LANs and LSPs
Note:
Note: The CLAN boards must be TN799DP running version 5 or greater firmware. Be
sure to check the firmware version for these boards on the media server. For
information on how to upgrade the firmware on the S8400, S8500 or
S8700-series Media Server, please see the "Upgrading firmware on
programmable TN circuit packs," in Upgrading, Migrating, and Converting Avaya
Media Servers and Gateways, 03-300412.
To assign node names and IP addresses
Note:
Note: At the SAT prompt, type change node-names ip to open the Node Names
screen.
Example Node Names Screen
1. Enter the name and IP address for the C-LANs and LSPs.
2. Press F3 (Enter) when complete.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-1-clan __
192.168.1 _.124 _______________ ___.___.___.___
node-2
-clan 192.168.1 _.97_ _______________ ___.___.___.___
node-10-lsp
192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp
192.168.1 _.51_ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___