Filter
Top Products
Installing a new G700 with an S8300 using the Avaya Installation Wizard
192 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
2. Verify that the G700 media gateway has registered.
The y in the registered field signifies that the G700 media gateway has registered. If the
G700 should become unregistered, the y will become an n, but the IP address will remain
assigned to the G700 media gateway. If the G700 has never been registered, the IP
Address field will be blank.
If the G700 fails to register, two common causes are:
- The serial number added as the Identifier for the G700 is wrong. To check, log back into
the G700 gateway and type show system. Check the serial number that appears.
- There is no IP connection between the G700 and the S8300. To check, type show mgc
and then ping mgp <controller_address>.
To enable announcements, if necessary
1. Only if specifically requested by the customer or your planning documents, at the SAT
prompt, type enable announcement-board <gateway_number> V9
where <gateway_number> is the number of the G700 media gateway you added.
V9 is the virtual slot (for example, 2V9 means media gateway number 2, slot V9.
2. Press Enter to enable announcements.
The system displays the message
Command successfully completed
To save Communication Manager translations
Save translations again after all Communication Manager administration is complete.
1. At the SAT prompt, type save translation