Avaya G700 Home Theater Server User Manual


 
Installation and wiring of telephones and power supplies
Issue 9.1 June 2006 377
Up to 20 redundant-port pairs are supported to increase link resiliency.
Inter-module redundancy is supported with one pair in a stack. The switching time is
approximately 1 second.
Link Aggregation Group (LAG) support of up to 7 trunks, with each trunk having up to 8 10/
100 links or 2 GB links, provides resiliency, load balancing, and bandwidth expansion.
LAG redundancy is supported through resiliency between two LAG groups.
Port mirroring of any switch port is supported.
RMON/SMON port statistics provide real-time top-down analysis of network traffic.
IP multicast filtering (snooping) filters multicast traffic to optimize network bandwidth.
Classification of ports as regular or valuable is supported so that if a link fails, notification is
generated for valuable ports only.
The L2 CAM table contains 16K MAC addresses.
Layer 3 features
Note:
Note: An additional license is required for Layer 3 features.
Static, RIPv1, RIPv2, OSPF IP routing protocols are supported.
Equal cost routing is used for load balancing and redundancy.
Router redundancy (VRRP) is supported.
NetBIOS rebroadcasting is available for applications such as WINS that use broadcasting
but may need to also communicate with stations on other subnets or VLANs.
ICMP and ARP protocols are supported.
DHCP/BootP relay allows broadcast requests to be forwarded to servers.
Policy-based routing of packets provides enforcement of QoS and ACL rules.
The L3 CAM table contains 4K IP addresses.
Management
Access to the management interfaces are password-protected at three levels (read-only,
read-write access and supervisor) to prevent unauthorized configuration changes.
You can access to the Command Line Interface (CLI) in the following ways:
- Direct console or modem connection
- Telnet (up to five simultaneous connections) or SSHv2 (up to two simultaneous
connections) over the IP network
You can use TFTP for the download/upload of configuration files or the download of
firmware files