Filter
Top Products
Manual installation of a new G700 without an S8300
558 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Note:
Note: For an S8500 or S8700/S8710 primary controller, if you enter a combination of
both C-LANs and LSPs, you must list C-LANs first.
2. Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 media gateway
processor.
A system prompt asks you to confirm the reset.
3. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type session mgp.
At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
Note:
Note: Because the G700 media gateway has registered with its primary controller, the
prompt name has changed; for example, to MG-001-1.
Type show mgc to display the list of available servers and their IP addresses.
For example:
Show Call Controller Status Screen
The Gateway will have registered with the primary controller, if present. If the primary
controller is running and has been administered properly, the Registered field says YES
and the H248 Link Status says UP. If the controller is not running, the Registered field says
NO and the H248 Link Status says DOWN.
MG-001-1(configure)# show mgc
CALL CONTROLLER STATUS
------------------------------------------
Registered : YES
Active Controller : 135.9.71.95
H248 Link Status : UP
H248 Link Error Code: 0x0
MGC List Management : Static
CONFIGURED MGC HOST DHCP SPECIFIED MGC HOST
-------------------- -----------------------
135.9.71.95 -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --
- Not Available -- -- Not Available --