Filter
Top Products
Upgrade the S8300
Issue 9.1 June 2006 697
6. Click Continue.
The S8300 displays the Install in Progress screen.
7. The installation should take 10 to 20 minutes.
The Install in Progress screen refreshes every 10 seconds or on demand by clicking the
Refresh button. When complete, the S8300 displays the Reboot Server screen.
8. Click Reboot.
If IA770 is being used, it may take approximately 5 minutes to shut down IA770 before the
reboot begins.
The S8300 displays the Reboot in Progress screen.
Note:
Note: The reboot can take 20 minutes or longer. The system does not automatically tell
you when the reboot is complete.
Wait 5 minutes and then click Continue. If you click Continue before the reboot is finished,
the screen will display Expired Page. If you see the Expired Page message, refresh the
browser. If the Session Timeout screen appears, close the screen, logoff, and log on
again. Click the Pickup button.
If IA770 is being installed when you click Continue and you get the Expired Page
message, enter the 192.11.13.6 URL in the address window of your browser. When you log
in you will be able to monitor the IA770 installation progress.
9. When the reboot is complete, clicking Continue will display the Update Tripwire Database
screen.
10. Unless instructed in your planning documents to update the tripwire database, select Do
not update the tripwire data base now and click Continue.
The system displays the Installation Complete screen.
11. Click Close.
You are returned to the main menu.
12. Under Server, click Software Version to verify the new software version.
!
Important:
Important: After upgrading an S8300, you must upgrade the G700 or G350 and media
module firmware before restarting IA770.