Filter
Top Products
Manual upgrade of an existing S8300A and G700 to R3.1
590 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
The steps to upgrade an S8300 configured as an LSP are the same as the steps to upgrade an
S8300 configured as the primary controller, with the following additional considerations:
● The version of Communication Manager running on the LSP must be the same as, or later
than, the version running on the primary controller.
● If upgrading both the primary controller and the LSP, the LSP must be upgraded first.
Then, with Communication Manager turned off on the LSP, the primary controller is
upgraded.
● Do not save translations on an LSP.
!
CAUTION:
CAUTION: These upgrade procedures require remastering the hard drive on the S8300B.
This can result in a service interruption of 3–4 hours, or up to 6 hours if IA770 is
being used.
Tip:
Tip: You may skip some of the procedures described in this chapter depending on the
upgrade scenario. Watch for the skip to instructions.
Release 3.1 upgrade scenarios
The upgrade procedures are slightly different depending on the upgrade scenario. The main
differences between the scenarios are summarized in Table 39
and are noted in the detailed
procedures.
The unshaded cells in this table are the most common and recommended upgrade scenarios.
The shaded cells are scenarios that are unlikely or not recommended.
Table 39: Release 3.1 upgrade scenarios
Upgrade From
S8300 B Hard Drive has
Remastering Software
Only
S8300 B Hard Drive has
R2.x Software Installed
R 1.x
Linux Migration backup
Remaster and upgrade
View/Restore Data
Linux Migration backup
Upgrade
View/Restore Data
R 2.x
Backup Now
Remaster and upgrade
View/Restore Data
Backup Now
Upgrade
View/Restore Data
Move hard drive from A to B
Upgrade