Filter
Top Products
Administer Communication Manager
Issue 9.1 June 2006 175
2. Enter the name and IP addresses for the LSPs.
3. Press F3 (Enter) when complete.
Administering Network Regions
Before assigning an IP network region to a G700, you must define network region on the IP
Network Region form. After a network region is defined, you can assign it to the various network
elements (servers, gateways, IP phones).
The information you need to do this should be provided in your planning documentation. Use
the system defaults if the planning documentation does not specify otherwise.
For a G700 with an S8300 as primary controller, there will usually be one network region,
defined as 1. The procedure below uses 1 for the network region number as an example but the
procedure applies for any network region number from 1 to 250.
To define IP network region 1
!
CAUTION:
CAUTION: Defining IP network regions can be quite complex. For detailed information on
the use and administration of IP network regions, see ‘‘Administration for Network
Connectivity for Avaya Communication Manager, 555-233-504.’’
1. At the SAT prompt, type change ip-network-region 1.
The S8300 displays the IP Network Region screen.