Emerson HASXEE-IM-HS TV Video Accessories User Manual


  Open as PDF
of 502
 
Emerson Process Management GmbH & Co. OHG4-24
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
04/2010
4.5.2 Installation - X-STREAM XE Field Housings
Fig. 4-18: Terminal Block X1 - Analog Signals and Relay Outputs 1-4
Note!
Consider the installation notes in section
4.6.and the notes on installing cable glands
on page 4-22.
Pin Signal
P2.1 Channel 1, (+) 4 (0) - 20 mA
P2.2 Channel 1, GND
P2.3 Channel 2, (+) 4 (0) - 20 mA
P2.4 Channel 2, GND
P2.5 Channel 3, (+) 4 (0) - 20 mA
P2.6 Channel 3, GND
P2.7 Channel 4, (+) 4 (0) - 20 mA
P2.8 Channel 4, GND
P2.9 Channel 5, (+) 4 (0) - 20 mA
P2.10 Channel 5, GND
P2.11 not used
P2.12 not used
P3.1 not used
P3.2 not used
P3.3 Output 1 (Failure), NC
P3.4 Output 1 (Failure), NO
P3.5 Output 1 (Failure), COM
P3.6 Output 2 (Maintenance Request), NC
P3.7 Output 2 (Maintenance Request), NO
P3.8 Output 2 (Maintenance Request), COM
P3.9 Output 3 (Out of Spec), NC
P3.10 Output 3 (Out of Spec), NO
P3.11 Output 3 (Out of Spec), COM
P3.12 Output 4 (Function check), NC
P4.1 Output 4 (Function check), NO
P4.2 Output 4 (Function check), COM
P4.3 not used
P4.4
P4.5
P4.6
P4.7
P4.8
P4.9
P4.10
P4.11
P4.12
Relay Outputs
**)
Analog Outputs
Serial Interface
*)
**)
Conguration of relay output termi-
nals as per standard factory setting
(NAMUR status signals)
Analog signals
Relay outputs 1-4
Terminals for analog signals and relay outputs
1 - 4 are located on the outer left module
(terminal block X1; Fig. 4-18).
Specication of analog signal outputs: 4 (0) - 20 mA; burden: R
B
≤ 500 Ω
Specication of relay outputs 1-4:
Dry relay change-over contacts can be used as
NO or NC.
Electrical specication:
max. 30 VDC, 1 A, 30 W
 previous next