Filter
Top Products
Emerson Process Management GmbH & Co. OHG4-4
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
04/2010
4.3 Installation - Gas Preparation
The number of gas connections and their
conguration may vary according to analyzer
version and installed options.
All gas connectors are labelled and can be
found on the
•
analyzer’s rear panel (X-STREAM XEGP,
X-STREAM XEGC)
• underside of the analyzer (X-STREAM XEF,
X-STREAM XEFD)
Should it be necessary to open the gas lines,
the gas connectors should be sealed with
PVC caps to prevent pollution by moisture,
dust, etc.
Fig. 4-2: Labelling of Gas Connectors (example)
TOXIC GAS HAZARDS
Take care that all external gas pipes are connected in the described way
and that they are gastight to avoid leakages!
Faulty connected gas pipes lead to explosion hazard or even to mortal
danger!
Don‘t take a breath of the emissions! Emissions may contain hydrocarbons
or other toxic components (e.g. carbon monoxide)! Carbon monoxide may
cause headache, sickness, unconsciousness and death.
Do not confuse gas inlets and outlets. All gases supplied must be prepared
beforehand. When supplying aggressive gases, ensure that the gas lines
are not damaged.
Max. admissable pressure: 1500 hPa, except in units with integrated valve
blocks (500 hPa)!
Exhaust lines must be installed to incline downwards and be unpressurized
and protected against frost, and conform to legal requirements.