Filter
Top Products
Emerson Process Management GmbH & Co. OHG5-8
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
04/2010
5.4 Software
Component selection menu
Within the analyzer software, one can distin-
guish between analyzer related and compo-
nent related menus: While the rst contain
entries, relevant for the analyzer (e.g. time
setting), the second contain entries relevant
for a specic component (channel) only (e.g.
calibrating a channel).
For single channel analyzers, editing any
channel specic parameter will only effect
this one channel.
Different for multi-channel analyzers: Such
instruments require selecting a channel prior
to changing channel related parameters.
When a channel related menu entry is selec-
ted, automatically a SELECT COMPONENT
menu shows up, to select the component of
interest, or to cancel the current action.
Editing
The editing mode enables changing parame-
ters. It is initiated by pressing
enter.
If the selection is a parameter list, the current
entry is highlighted and may be changed by
up and down.
If the selection is a value, the cursor is placed
over the last character. Use up and down to
change it.
Use
left and right to select another charac-
ter.
The type of available characters depends on
the position of the cursor:
• It is not possible to select the minus sign or
decimal point as the last character
.
• It is not possible to select the decimal point
in integer values
.
• For decimal numbers, the decimal point can
be placed anywhere within certain limits.
There are two ways to exit the data entry
mode:
enter: the entry is veried.If it is accepted,
it is saved and the new value dis-
played; if not, an error message is
displayed
.
home: Cancel: all settings and changes are
reset to their former values.
Select the component / channel you want to
work with, and press enter.
This menu does not show on single-channel
units.
Within menu descriptions, the following points
out, that for multi-channel instruments a selec-
tion is required:
Select Component
Component: Ch1
Press
to return
Multi-channel unit:
In SELECT COMPONENT select the chan-
nel to be ...