Filter
Top Products
Emerson Process Management GmbH & Co. OHG5-12
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
04/2010
If the analyzer is operational and it becomes
clear that the incorrect language has been
set, which is unintelligible to the operator, the
5.6 Selecting the Language
5.6 Selecting the Language
following sequence of keypresses (starting at
the measurement display) can be used to set
the language.
• down changes the language.
• enter sets this language and the display is
updated accordingly.
• If the selected language is not the intended,
repeate the last three steps until the inten-
ded language is set.
Note!
Pressing
enter the 3
rd
time in this sequence
highlights the "Language” line.
If the system has been set up accordingly,
the code for access level 1 must be entered
at this point to enable access to the following
menu.
Note!
The factory setting for this unit is "no code
required”. For ease of operation, it is recom-
mended to use the factory settings for access
codes while setting up the unit for the rst
time. In the following sections, therefore, no
more reference will be made to any need for
entering a code.