Filter
Top Products
Emerson Process Management GmbH & Co. OHG 8-19
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
06/2010
8
Troubleshooting
8.4 Troubleshooting on Components
HAZARD FROM EXPLOSIVE, FLAMMABLE AND HARMFUL GASES
Before opening gas paths they must be purged with ambient air or neutral
gas (N2) to avoid hazards caused by toxic, ammable, explosive or harmful
to health sample gas components!
HIGH TEMPERATURES
While working at internal components hot surfaces may be accessible, even
after the instrument has been disconnected from power!
ELECTROSTATIC DISCHARGE HAZARD
Working at internal components of electronical and electrical instruments
may cause electrostatic discharge (ESD), destroying components!
We recommend special antistatic workplaces for working at open instruments!
If no such workplace is available, at minimum perform the following
procedures to not destroy electronic components:
Discharge the electric charge from your body. Do this by touching a device
that is grounded electrically (e.g. instruments with earth connectors,
heating installations). This should be done periodically when working at
open instruments (especially after leaving the service site, because e.g.
walking on low conducting oors might cause additional ESD).