Filter
Top Products
Emerson Process Management GmbH & Co. OHG 6-29
X-STREAM XE
Instruction Manual
HASXEE-IM-HS
06/2010
6
Software Menus
6.2.3.1.3 Measurement Display Setup Menu
6.2.3 Setup Menu
Enter this menu to congure the measurement
display.
The MEASUREMENT DISPLAY may be
congured as a single or dual page version,
where the content of each page can be con-
gured separately by a related page within
this setup menu.
The rst setup menu page ('Display 1 ...') con-
gures the rst MEASUREMENT DISPLAY
page. You may specify up to 5 measurements
to be shown on the page. If only up to two pri-
mary and one secondary measurements are
congured, the display will use the 2 lines lay-
out with bigger characters. Enter the second
menu page ('Display 2 assignments') to setup
a second MEASUREMENT DISPLAY page.
If the system is setup accordingly, the access
code for level 2 must be entered to gain ac-
cess to this menu.
Setup..
Display..
Measurement Display..
On either setup menu page, highlight the line
to be congured, press enter and then select
the parameter to be displayed in the related
line by means of up / down.
Available options:
Comp1 ... Comp5
Temp1 ... Temp5
Flow1 ... Flow5
Press1 ... Press5
CalcA ... CalcD
Blank
Congure the labels 6-30.
Display 1 Assignments
Line 1: Comp1
Line 2: Comp2
Line 3: Comp3
Line 4: Comp4
Line 5: Flow1
Labels..
Display 1 Assignments
Line 1: Comp1
Line 2: Comp2
Line 3: Comp3
Line 4: Comp4
Line 5: Blank
Labels..
Display 2 Assignments
Line 1: Comp1
Line 2: Comp2
Line 3: Comp3
Line 4: Comp4
Line 5: Blank
Labels..
Note!
Primary measurements are gas measure-
ments. Secondary measurements are pres-
sure, ow, temperature; these are always
displayed with the smaller font.