Filter
Top Products
3
Installing a New G700 with an S8300
Install New Software on the S8300
122 Installation and Upgrades for G700 and S8300
December 2003
If the AUDIX installation has not completed, the following warning screen will appear.
CAUTION:
If this warning screen appears, close the telnet session, wait about 5 minutes, and try
again.
2 At the telnet prompt, type cd /var/home/ftp/pub and press Enter to access the FTP directory.
3 At the prompt, type ls -ltr and press Enter to list files in the FTP directory.
The S8300 displays a list of files in the FTP directory.
4 Verify that the directory contains the update .tar.gz file you have uploaded, if any.
5 Type update_unpack <update> .tar.gz, where <update> is the release or issue number of the
latest update file. (For example,
00.0.218.4-1003.tar.gz). Press Enter.
6 Type update_show again and press Enter to list Communication Manager files to verify the new
software file was installed.
7 Type update_activate <update>, where <update> is the release or issue number of the latest
update file. (For example,
00.0.218.4-1003. Do not use the .tar.gz extension at the end of the file
name). Press
Enter.
The S8300 goes through a software reset system 4. The S8300 also may display the message
/opt/ecs/sbin/drestart 1 4 command failed. Ignore this message. You must wait until the
restart/reset has completed before entering additional commands.
The S8300 displays a message that the update was applied.
8 Type update_show again and press Enter to list Communication Manager files to verify the new
software file was applied.
Install IA770 update (patch) files, if any
If IA770 is being used, a post-upgrade update (patch) for IA770 may be required. See the IA770
documentation for procedures to install an update. The documentation can be found on the Avaya
Support Web Site at http://support.avaya.com. Then click on Product Documentation and then
Messaging and scroll down to the INTUITY document links.