Filter
Top Products
6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Upgrade the Firmware on the G700
292 Installation and Upgrades for G700 and S8300
December 2003
Determine Which Firmware to Install on the
G700
Conduct the following procedure to compare software versions running on the G700 processors and
media modules with the versions in you planning documents. If the versions do not match, new firmware
for those components is necessary.
Determine if new firmware for the P330 stack processor is necessary.
1 At either the P330-1(super)# or P330-1(configure)# prompt, type dir.
The system displays the list of software.
Directory List for P300 Processor
2 Check the version number (ver num) of the EW_Archive file to see if it matches the Release
Letter. If not, you must upgrade the P330 stack processor.
3 Type show image version
The system displays the list of software.
Show Image Version List for P330 Processor
4 Check the version number of the stack software image file in Band B to see if it matches the your
planning document. If not, you must upgrade the P330 stack processor.
Determine if new firmware is required for the MGP, VoIP Module, and installed media
modules.
1 Type session mgp
2 At the MG-001-1(super)# prompt, type show mg list_config
The system displays the list of software.
M# file ver num file type file location file description
-- ---- ------- ---------- ------------- ----------------
1 module-config N/A Running Conf Ram Module Configuration
1 stack-config N/A Running Conf Ram Stack Configuration
1 EW_Archive 3.8.6 SW Web Image NV-Ram WEB Download
1 Booter_Image 3.2.5 SW BootImage NV-Ram Booter Image
Mod Module-Type Bank Version
------ ----------- ---- -------
3 Avaya G700 Media Gateway A 0.0.0
3 Avaya G700 Media Gateway B 3.9.0