Filter
Top Products
4
Installing a New G700 without an S8300
Administer Communication Manager
198 Installation and Upgrades for G700 and S8300
December 2003
Administer Communication Manager
Perform one of the two administration procedures in this section:
• When the The Primary Controller is an S8300, or
• When the The Primary Controller is an S8500 or S8700
The Primary Controller is an S8300
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer’s network. For the majority of
administration required, see ‘‘Administrator’s Guide to Avaya Communication Manager, 555-233-506,’’
or ‘‘Administration for Network Connectivity for Avaya Communication Manager, 555-233-504.’’
In this section, you will use the SAT interface to:
• Assign Node Names for LSPs
• Define the IP Network Region
• Add a Media Gateway.
CAUTION:
Before continuing, be sure you have saved translations in Communication Manager.
Reset the System
1 Telnet to the S8300, log in, and open a SAT session (type sat or dsat).
2 At the SAT prompt, type reset system 4
The system reboots.
3 After the reboot is complete, telnet to the S8300, login, and open a SAT session.
Assign Node Names and IP Addresses for the
LSPs
If the S8300 network configuration includes LSPs, they must be specifiied on the Node Names form.
Assign node names
1 At the S8300 SAT prompt, type change node-names ip to open the Node Names screen.
Example Node Names Screen
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
default_________ 0__.0__.0__.0__ _______________ ___.___.___.___
node-10-lsp
192.168.1 _.50_ _______________ ___.___.___.___
node-11-lsp
192.168.1 _.51_ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___
_____
_____ ___.___.___. _ _______________ ___.___.___.___