Filter
Top Products
3
Installing a New G700 with an S8300
Configure the G700 Media Gateway
140 Installation and Upgrades for G700 and S8300
December 2003
8 Select Yes at the dialog box that asks if you want to continue.
The prompt will change to P330-1(configure)#
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
9 When the mgp reset is complete, type session mgp.
10 At the MG-???-1(super)# prompt, type configure to reach the configuration level of the
command line interface.
11 Type show interface mgp to verify that the G700 Media Gateway has the correct IP address.
Assign an IP Route for the Default Gateway
The default gateway is a router or switch that routes packets to destinations outside of the local
subnetwork.
1 At the MG-???-n(configure)# prompt, type set ip route <destination> <netmask>
<default_gateway_ip_address>
. Both <destination> and <netmask> are 0.0.0.0 for the default
gateway. <default_gateway_ip_address> is the IP address of the router or switch that is
designated to handle packets addressed to destinations outside of the local subnetwork.
2 Type show ip route mgp to view the results.
3 Repeat <~Link>step 1 for additional ip routes, if needed. Usually, only a default route is needed.
Refer to your planning document.
Assign IP Addresses to the VoIP Resources
From the G700 Media Gateway Processor command line interface, you will assign IP addresses to
the VoIP resource resident on the G700 Media Gateway and to any installed MM760 VoIP Media
Modules.
1 At the MG-???-n(configure)# prompt, type set interface voip <number> <ip address>
For example: set interface voip v0 132.236.73.3
<number> is the slot number of the VoIP media module. v0 designates the VoIP resource resident
on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are designated
according the slot (for example,
v1, v2, v3, v4) in which the Media Module has been installed.
<ip address> is the IP address of the VoIP resource.
2 Type show interface to display a table of all configured interfaces, including all VoIP Media
Modules.
3 Type show voip v0 to display the VoIP resource on the motherboard.
NOTE:
It is not necessary to configure the VLAN, netmask, or IP routes for VoIP engines. The
media gateway parameters are applied automatically.
Check for IP Connections
After you have assigned IP addresses to the P330 Stack Processor (Layer 2 Switching Processor), the
G700 Media Gateway MGP, Media Modules, and the VoIP resources, do the following procedure to
validate the IP connections.