Filter
Top Products
6
Upgrading an Existing G700 with an S8300 — R2.0 to R2.x
Upgrade the Firmware on the G700
Installation and Upgrades for G700 and S8300 295
December 2003
6 At the MG-???-1(configure)# prompt, type reset mgp.
A system prompt asks to confirm the reset.
7 Select Yes at the dialog box that asks if you want to continue.
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
8 When the P330-1(super)# prompt appears, type session mgp.
9 At the MGP-???-1(super)# prompt, type configure.
10 Verify that the download was successful when the prompt returns.
Type
show mg list_config. The system displays the list of software.
Example: Show mg list_config
Install New Firmware on the Media Modules
For upgrades of active media modules, you need to take the media modules out of service before
initiating the upgrade process. To do this, go to a SAT session on the primary controller and issue a
busyout command.
NOTE:
Skip this busyout procedure if the media modules are not in service; for example during
an initial installation.
Busyout board (for active media modules)
1 Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2 Verify the response, Command Successfully Completed.
3 Repeat for each media module to be upgraded.
Install media module firmware
1 Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on the
G700 motherboard) (see Determine Which Firmware to Install on the G700
). This VoIP module
does not occupy a physical position like other Media Modules.
2 At the P330-1(configure)# prompt, type session mgp.
SLOT TYPE CODE SUFFIX HW VINTAGE FW VINTAGE VOIP FW
---- ------ ----- ------ ---------- ---------- -------
V0 G700 DAF1 A 00 230(A) 67
V1 ICC S8300 A 72 00 N/A
V2 DCP MM712 A 2 58 N/A
V3 ANA MM711 A 2 57 N/A
V4 DS1 MM710 A 1 58 N/A